Hope Pro 2 Hubs – what holds the 20mm adapters in?

as it says – just go one and they just seem to fall out. Looked on the Hope web-site and it doesn’t seem to show any circlips or anything………. or do they just sit in loose?

thanks multo

no, they use circlips

The spacers?

On my bulbs theres a circlip on each side

Their held in with a fine stainless type of circlip (a bit like a thin piston ring), plain with no hole for pliers. Best to use a small blade or jewellers screwdriver to gently prize one end out, then folow it round till its out.

thanks – though so. Are there any o rings or anything between the spacer (better word than adapter) and the bearing – doesn’t seem that well sealed.

cheers again

Bulbs and pro II both use clips to hold the spacers