Home Forums Bike Forum Outer bearing race stuck in hub body – any ideas how to remove please?

Viewing 10 posts - 1 through 10 (of 10 total)
  • Outer bearing race stuck in hub body – any ideas how to remove please?
  • diplomatt
    Free Member

    Hi

    I’ve got a Hope Pro 2 Evo rear hub that developed a load of play mid-ride. Nursed it home and disassembled. Drove the non-drive-side bearing out with a single hammer strike on the axle. Then put the axle back through the drive-side bearing and it disintegrated on the first strike leaving some of the outer race stuck in the hub body. Ar$e. Looking through from the non-drive-side there doesn’t appear to be anything to go at to remove it. Anyone got any ideas please?

    Cheers

    Matt

    TandemJeremy
    Free Member

    Are you sure you cannot get anythin on the back of it?

    If not the proper answer is a blind bearing puller. sometimes you can bodge something up with a rawlbolt

    A trick that might work is to heat the hub up – tie a rag around it and pour boiling water over it then hit the wheel down onto a hard surface on the drive side – momentum might just start the bearing moving

    cynic-al
    Free Member

    Wot TJ says, a dremel is likely to trash the hubshell.

    Coulda woulda shoulda bought shimano 😉

    The rawlbolt trick is worth a try.
    Welding a bolt to the remains of the bearing never fails.
    the heat of the weld will loosen it and the bolt gives you something to pull on.

    greeble
    Free Member

    this has happened to me a few times I used a dremel with a tungsten carbide cutter attachment

    http://www.wonderbart.com/images/09/april/dremel_tungsten_carbide_cutter_bit.jpg

    cut 3/4’s the way into the race every 1/3’s around the circumference and used a small chisel to break the race out.

    TandemJeremy
    Free Member

    A engineering shop should have a blind bearing puller and with one its a 2 minute job – I would do that before risking damage to the hub

    j-cru
    Free Member

    I had the same problem with pro 2, was a front hub tho. Heated it up in oven then drifted out the remains with a park metal tyre lever, the curved tip just caught enough of the race.

    diplomatt
    Free Member

    Cheers for the responses chaps. Had another go at it and found the smallest of lips to work on. Once I’d got it out it turns out the hub shell has cracked round the bearing seat which explains why the bearing failed as it did. Arse.

    Matt

    cynic-al
    Free Member

    Hope should warranty it?

    wwaswas
    Full Member

    +1

Viewing 10 posts - 1 through 10 (of 10 total)

The topic ‘Outer bearing race stuck in hub body – any ideas how to remove please?’ is closed to new replies.