Home Forums Bike Forum how do you extract spoke niples trapped in a rim?

Viewing 24 posts - 1 through 24 (of 24 total)
  • how do you extract spoke niples trapped in a rim?
  • big_n_daft
    Free Member

    as title

    HELP!!!

    cynic-al
    Free Member

    Just glue it in

    dudeofdoom
    Full Member

    Do you mean rattling around in the double wall or stuck in it ?

    househusband
    Full Member

    With patience… and cocktail sticks worked for me!

    Thrustyjust
    Free Member

    Shakey, shakey…….

    dudeofdoom
    Full Member

    I do shakey then use a spoke to catch it on but gotta watch out for swarf if your sorta underneath it looking up …

    don’t want alloy in yer eye 🙁

    big_n_daft
    Free Member

    rattling around

    coatesy
    Free Member

    I usually bang it on the floor,and shake it at all sorts of angles for about 5 mins, then say “!”£$%^&* it.”, and put it to one side, at which point it normally just falls out.

    big_n_daft
    Free Member

    coatesy
    tried that several times, still stuck!

    DT78
    Free Member

    I just rebuilt my front wheel, super fast, tubeless went up first time. First ride out. Rattle rattle like spoken dokeys. Really annoyed, but when you are riding you can’t actually hear it over the trail.

    singlespeedstu
    Full Member

    I normaly get them to shake out through the valve hole.

    reedspeed
    Free Member

    With a blob of silcone !,turn the wheel till the nipple hits the silcone,let it dry ,no more annoying noise !.. Simples ..

    chrishc777
    Free Member

    Lots of shaking and a cable tie

    Sam
    Full Member

    Blob of grease on a toothpick, shake until nipple hits it, then maneuver it out.

    gofasterstripes
    Free Member

    Vaccum cleaner positioned on valve hole and shake?

    rankbadjin
    Free Member

    I done this recently building a pair of nexties, gave the angry shake a go to no avail.
    Ended up taping up all the holes bar one, shoogle it so the nip was roughly around the uncovered hole then henry hoover done the rest!

    tomhoward
    Full Member

    Cut it in half.

    Oh, you want to reuse the rim?

    gofasterstripes
    Free Member

    If in doubt,
    suck it out!

    Eeeer, IGMC

    citizeninsane
    Free Member

    Stick a spoke through the hole and shake the wheel till the nipple comes round and gets stopped by the spoke. Pluck it out with a pair of tweezers.

    parkesie
    Free Member

    Shoogle it out .

    big_n_daft
    Free Member

    In the end it was shaking and lots of patience

    gofasterstripes
    Free Member

    In the end it was shaking and lots of patience

    I think might have that on my headstone.

    kimbers
    Full Member

    I had an emergency wheelbuild , lbs lost a nipple in there couldn’t get it out, but I was in a rush, planned to work it out when i got hom, tied it on the back of the trailer, (I was on the nursery run), rode a few km back to nursery, got the kids, by the time I’d cycled home (5km) it’d worked itself out

    rickon
    Free Member

    Aluminium Magnets.

Viewing 24 posts - 1 through 24 (of 24 total)

The topic ‘how do you extract spoke niples trapped in a rim?’ is closed to new replies.