MegaSack DRAW - This year's winner is user - rgwb
We will be in touch
Standard car, thinking of getting both sides done (only one side bad). I was thinking it'll be circa 150?
Check out eurocarparts for price of part and DIY with an angle grinder its a piece of piss
£20 for the parts and if you're lucky you won't even need a grinder/hacksaw.
I went for mid range Lemforders from Eurocarparts for my Civic at about 55k, they did 110k after that and were still fine. £40 at the time IIRC
As above, Grinder > Hacksaw. I went through a few blades and a good hour before I gave up and got on the phone to my old man for his grinder, got the job done in half an hour once I had it.
The issue is its now winter and I don't have undercover ability. Plus I'm quite hamfisted (ssshh Chrisdiesel)
£50 inc the parts (no name cheapies) and labour on my Outback. They lasted a year, just.
What car and where are you?
[img] 
[/img]
Standard car you say.. I give you the vanguard.
I think your guess is spot on for decent bits at an Indy.
But again it really is a simple job.
Saab 9-5 Aero, Manchester
Eurocarparts or eBay - literally is a couple hours work.
Give the old ones a good clean as some use either a hex or TX inside the thread to hold it stationary whilst you undo the ball joint.