What’s the best practice when cutting a bath panel for a nice clean edge and preventing loss of fingers? Fine tooth saw, stanley knife, jigsaw? I have clamps and straight edges to assist.

Advice / experience welcome before the usual “measure twice, cut once”

What’s it made from?

What’s it made from?

Whoops that would help…

Usual white plastic, not a cheap thin one though, hence the check before I cut it.

This would be my weapon of choice: https://www.screwfix.com/p/irwin-pullsaw-7-185mm/5797x Cuts thin plastic nicely. Doesn’t stress the material.