I' sure someone here is an expert on the above^^
I need to replace a really tiny E-Clip as seen on the picture below.
Do you reckon this ebay e-clip will fit ?
Any thoughts.
[url= http://farm8.staticflickr.com/7375/9092887983_a2a09556b5_b.jp g" target="_blank">
[url= http://www.flickr.com/photos/58162507@N07/9092887983/ ]P1120388[/url] by [url= http://www.flickr.com/people/58162507@N07/ ]SGMTB[/url], on Flickr
[url= http://farm3.staticflickr.com/2847/9092888247_dca3c65d8b_b.jp g" target="_blank">
[url= http://www.flickr.com/photos/58162507@N07/9092888247/ ]P1120391[/url] by [url= http://www.flickr.com/people/58162507@N07/ ]SGMTB[/url], on Flickr
I don't think so.
I reckon that shaft has an OD of 2.4mm and the ID of the e-clip is 2.5mm.
Could be wrong.
It'll be less than that; the section where the circlip sits is thinner than the OD you can see. I'm guessing it's about the same as the black tip, which looks to be ~1.6mm.
From http://stores.ebay.co.uk/CLIPS-BITS?_trksid=p2047675.l2568 they do one:
10 x 1.5mm 2-2.5mm
That's the one you'd need, I reckon. If I were you though, I'd email them your picture and ask them the question.
Not cheap, are they?
How about..
1.5mm fits 2mm-2.5mm shaft
From this one:
Thanks for the info so far 🙂
Sounds about right to me.
I Am Not A Circlip Expert.
Also,
There's a DIN standard for circlips? Who knew.
Sounds about right to me.I Am Not A Circlip Expert. "
As far as I'm concerned you are at the moment.
Thanks.
I mean Expert ^^
Is that £9.99 EACH?!!
Cheers
Danny B
pop it off (carefully) and measure the diameter.
Or better still the groove diameter with some calipers.
Something like the 1.5mm should fit though by the looks of it.