If so - are the tabs ISCG old or ISCG 05?
Also, I've been looking at the Gamut P30 but seems a lot of money when copared to a blackspire stinger (providing my old Saint bashguard will fit my XTR crank)
Is it as simle as taking off the outer ring? Do I not have to adjust the mech cable or the screw limiters? Will I have to start filiong it away to make it fit?
Any advice from people who've done it would be great
I've gone double and bash and haven't needed a chain device but if I was going that route I think it's ISCG old. I considered 1 x 10 and had decided on the blackspire but in the end decided to keep my granny!
You need to take the big ring off, you will also obviously have to take the cranks off to fit the chain tensioner. It may be worth taking a few links out of your chain once you've done it.
The Gamut P30 is rubbish tbh, I have it, there is much better out there.
If you get a P30 the top ISCG hole isn't as deep as the rest, the screws are too long, then break or round off if your cack handed like me.