Topic starter
Just had notification that the rim is finally on stock and is on its way.
Thinking about building it myself so perennial spoke length question.
1) What adjustments do you need to make for the spoke offset? One piece of info I've been given was to change flange sizes on the spoke calculator. But what adjustment is needed? It's it taking the offset from the midline of the spoke hole and deduct from flange width or is it a deduction of twice the offset to cater for 'top' and ' bottom' spokes (as cross section of hub)
2) Any strange dish requirements for a 170 On One hub or just equal spacing from hub ends to rim?
3) Any other tips/tricks? Other than 'Take it to someone that knows what they're doing'...
Northwind pitch in!
Posted : 04/06/2016 10:14 am