This is how big of a gap there is between the caliper and IS adaptor....
The frame did come with two spacers which are quite thick, and equal to the DMR swopout dropout width from what it should compensate (as far as i understand).
However I would need 4 of these spacers to fit two bolts through in this case. Where can I get them from?? Am I doing this wrong?
On kinesis website it shows the dropouts being fit the exact way I have done, but I could fit the on the outside instead of inside, which would mean only two spacers would be required. However then the frame is forced together, and would probably miss-align the brakes.
HELP! 
P.S I also need some decent chain tugs, anyone can recommend? I have a standard QR axle. Or should I not bother and use the vertical dropouts + buy tensioner??
