KCNC BB90 BB in 92mm shell – spacer needed ?

Home Forum Bike Forum KCNC BB90 BB in 92mm shell – spacer needed ?

Viewing 1 post (of 1 total)
  • KCNC BB90 BB in 92mm shell – spacer needed ?
  • allthepies
    Member

    As subject, if I’m fitting a kcnc bb90 pressfit to a 92mm shell then do I need the drive side spacer ? I’m going to use HT2 cranks. I think the spacer is only there for 89mm shells and I should remove it. Correcto ?

Viewing 1 post (of 1 total)

The topic ‘KCNC BB90 BB in 92mm shell – spacer needed ?’ is closed to new replies.