Comute lights.....H...
 

[Closed] Comute lights.....How bright is to bright?

Posts: 351
Free Member
Topic starter
 

I use a MAXX D up front (only on low or flash on the road) and a red eye rear. When I drive I would rather be able to see a bike stand out against traffic instead of that single blinking led with last winters batteries in it.

Your thoughts?


 
Posted : 16/12/2011 3:41 pm
Posts: 7100
Free Member
 

I use my Maxx D on the road, on full power when there is no street lighting and no cars about. Even then it's not a problem, but I usually have it on low in traffic or on strobe on roaundabouts or busy junctions. If you have it angled right it won't dazzle drivers. On Low / Med it lasts me all week before a charge. I use a red eye at the back. Plus hi-viz/reflective jacket.

Avoid the road route usually and go off road for 90% of the journey. Only go on the road if I'm in a hurry.


 
Posted : 16/12/2011 3:47 pm
Posts: 0
Free Member
 

I agree.


 
Posted : 16/12/2011 3:48 pm
Posts: 0
Free Member
 

Maxx-D full power, definitely not flash. Dont want folk to have fits now do we.


 
Posted : 16/12/2011 3:49 pm
Posts: 7100
Free Member
 

Dont want folk to have fits now do we.

Not sure the frequency of the flash is high enough to be a problem.


 
Posted : 16/12/2011 3:50 pm
Posts: 0
Free Member
 

I have started using my Lumen Liberator on my commute and feel so much safer. I use it on low flash and traffic seem to give me more respect.

I was also out riding on quite country lanes last night and every car I came across pulled in to let me come past. Unheard of during the day.


 
Posted : 16/12/2011 3:53 pm
Posts: 0
Free Member
 

Is there such a thing as too bright? So long as the light is angled down a bit so it doesn't blind drivers, I'd think the brighter the better.


 
Posted : 16/12/2011 4:37 pm
Posts: 0
Free Member
 

Bright front light is a life-saver imo. I use a Lumen Liberator too for commuting. Tend to have it on full beam for any roundabouts, junctions, pot-holed bits of road, country lanes.
So pretty much all the time ๐Ÿ™‚

Goes on dip for nice car drivers travelling in the opposite direction that I think are nice.

Not so fussed about rear ones. I always have em, but haven't really noticed any change from drivers that varies with brightness.


 
Posted : 16/12/2011 4:44 pm
Posts: 0
Free Member
 

Having a really bright light is fine if it's a focused beam.

If I run my 3 x XPG light I get flashed by oncoming drivers even on lower settings as it's so floody. If I use my 2 x XML U2 light I get no bother.


 
Posted : 16/12/2011 4:48 pm
Posts: 12
Free Member
 

When I was a regular rural commuter, I sometimes used to get flashed by oncoming cars. Funnily, they were always Cheshire* Tractors.

Remember to get good side on visibility - front and back is easy, side less so.

*Cheshire = Chelsea, but even more unsuitable as there are grass verges to mount every now and again....


 
Posted : 16/12/2011 4:49 pm
Posts: 7100
Free Member
 

Remember to get good side on visibility - front and back is easy, side less so.

The newer Red-Eyes are pretty good from the sides, and also flood the ground at the back of the bike is red - pretty good.


 
Posted : 22/12/2011 3:14 pm
Posts: 0
Free Member
 

I am now using a joystick on the bars and got the flash and flare set of lights. Ive got he flash attached to my helmet works great.

The rear flare is great too, I have notice drivers giving my much more room since I started using it, more-so since I got one of those Respro/Hump reflective rucksack covers.


 
Posted : 24/12/2011 3:21 pm
Posts: 396
Free Member
 

brighter the better - twice recently when driving in the dark i've nearly failed to spot a cyclist approaching when waiting to pull out - both times the cyclist had a "standard" frontlight and was (almost) completely lost in the bright car headlamps behind - in urban areas the newer brighter car headlamps are just too bright - another great design f-up great for driving (too?) fast on dark A roads but totally unsuitable in town - masking out cyclists and peds


 
Posted : 24/12/2011 3:56 pm
Posts: 0
Free Member
 

A light to see by may not always be the best to be seenby - you want all round diffuse light to be seen by best - and a large area that is the light emmittin surface


 
Posted : 24/12/2011 4:00 pm