Really tempted by a lovely frame. It's got very neat internal cable routing, but as I wouldn't be using a front mech, it would have a couple of holes in the top tube to let in crap and generally mess with my head. I've seen racers who cover them with tape, but I'm more of a tart than that. What do you do? Ignore them, tape them, stick a flower in them, or something else?
I take the lack of response as encouragement to get a life. You're probably right.
Someone said to me, "silicon bathroom sealant that". But I didn't.
I put sugru in mine.
I ignored them. Two sets as it had internal routing for rear lockout I didn't use either.
[img] 
[/img]
Some manufacturers sell/give out blanking plates for surplus holes (fnar, fnar) what frame is it?
Fill them with your hopes and dreams
Somewhere to keep gravy? Handy as a Northerner living in the South, if I stop for a pie & chips after a ride I don't have to suffer the chippy' staff's blank stares when I ask for it....
I'm concerned that they might be somewhere for my riding buddies to post prawns.
It's a ti frame, so I doubt there are blanking plates.
Put a sticker over them
Reverb hose
I was wondering whether I could fit the rear brake hose through, although it is designed for a gear cable?
Rocketdog in internet forum fail.. 🙂
Keep your spliffs in them??
[img] 
[/img]
😉
(note to kids: DOn't do drugs, it's not big or clever.....)
Cable outer end cap turned 'upside down' and in hole.. assuming your internal routing is inner cable only
If you can't find your life, try [url= http://www.ebay.co.uk/itm/Rubber-Blanking-Grommets-6mm-Pack-of-25-/181177860166?pt=UK_Cars_Parts_Vehicles_Other_Vehicle_Parts_Accessories_ET&hash=item2a2f0ac046 ]These...[/url]