I can’t see anything on the instruction manual. How tight do people do them up?
Edit:
argh! Dam you auto correct- syntace, syntace, syntace
Off the top of my head it's 12 to 15 nm .
I am pretty sure it's written on my rear axle. Will double check for you.
Thanks, I’ve not taken mine off , bike shop built it from the parts on my old bfe last December, cause I,m lazy! Going to put the 2.4 ardent on tonight and try it out at FOD tomorrow morning.
cant see anything marked on mine.
Just looked. It says 10 to 16 nm on mine
Thanks - I’ll go with 13nm
Yes - 13 Nm sound right. That's what I use on mine as well.
All stuff "new": you have to check the torque two or three times.
Later in the game: the torque stays at it is.
Not been checked at all! Lucky it was still tight, I will remember that in future, thanks.