Topic starter
Muppet question:
Non drive QR cap comes off to reveal axle with 2 machined key slots. Drive side QR cap has a hex machining just a bit too big for a 5mm allen key to be really snug.
So, is it a matter of using the slots to hold the axle and the 5mm allen key and to unscrew the end cap? It seems to be on there worryingly tight and I dont want to round the machined flats on the cap.
Anyone done this? Is there something I'm missing?
Posted : 01/12/2012 7:11 pm
Topic starter
Yes is the answer, just needed a little more brute force and ignorance!
Posted : 01/12/2012 7:41 pm