Topic starter
Trying to make a fidlock bottle fit a very small space.. with a curved downtube making life tricky!
Is Sugru up to the task?
Or just suitable to use it to fill the space then rely on the unibase straps to do the holding?
Would prefer a clever 3d printed solution but resources not available locally and well, its been 15 years since I modeled anything complex!
https://tinyurl.com/y265rh9f
https://tinyurl.com/y4l3vptx
Posted : 29/04/2019 5:43 am
You could try using milliput to make something to fill the void. It dries very hard and you can cut and sand it finely.
https://www.milliput.com/howto.html
Posted : 29/04/2019 8:25 am