Looking for the internal diameter of the bars, to fit bar plugs?
Are they as follows:
Road bars 20mm
MTB bars 30mm
Are there other diameters, just checking?
Ta.
30mm ID for Mtb bar ends seems a bit big!
a lot are only 2.54 externally in the middle?
They vary hugely, by material, brand etc etc.
None will be 30mm though, road or MTB.
Sounds about right for oversized MTB bars, road is narrower so 20mm sounds ok.
If it helps (it probably doesn't) Standard sprit bottle tops fit over road bar ends with tape (Havana Rum looks nice).
Hmmm, not a simple answer then, darn!
Trying to order some custom made ones for a club, I new it was not going to be simple task.
Looks like I might have to go round with a tape measure 😉
Thanks for all the comments above btw.
OD is 22.2mm and 23.8 respectively or so I think. Wall thickness will vary of course.