That is a really cheap and nasty QR so I can completely believe it has been caught in the brake disc if not done up right.
I have also met someone on a ride last year who had just completed a very rocky downhill section on the mendips and I rode over and closed the QR on her front wheel for her while we were chatting.
The 'lawyer lips' are there to stop a wheel coming out should the QR slip (due to braking forces or otherwise). They will hold a wheel in sufficiently for someone with no real bike experience to notice.
I bet if I went over a fair few bikes of people posting here with a fine toothed comb I could find potentially dangerous faults they hadn't noticed. Horses for courses 'n all that....
I remember adjusting Kyle Straits back wheel that looked like that, it hadnt caused him to crash just the shifting was awful.
The thread title was really not a good idea. I've changed it.
The discussion as to what happened is just that, discussion of an incident.
But really... Please think twice before you post thread titles like that. It cause you and us and the company you are talking about nothing but problems.
But with no word of death or being killed this thread doesn't seem as appealing 😀
No! Silly! Far better to post inflammatory and possibly slanderous nonsense on the interwebz!
Agree. Or better still replace the shop name with the common placeholders 'Evans' or 'Halfords'. Then folk would be more accepting and believing.
There is quite a bit of paint damage in the dropout. I suspect that the QR was in the open position and probably bounced in and out of the dropout a few times, damaging the paint as it did so. Eventually the QR/skewer bounced out of the dropout and at the same moment the skewer moved further into the hub. As the weight of the rider, bike, forks pushed down towards the skewer again, it caught the QR level, which was now closer to the hub and bent it back into the disc. At this point the disc got bent, the wheel jammed and the skewer couldn't drop back into the dropout as the QR lever was now stopping any further movement.
I don't believe that the lever has been pulled around by the disc. The weight of the bike on the lever has just bent the lever into the disc.
Well that's what Miss Marple thinks!
Edited bit: Now I have seen Timb34's post above, I also think that is totally plausible.
Good to see that the title has been changed.
hey im sorry about the original title, it was a bit strong and i probably shouldnt have mentioned the shop just was a bit fired after hearing they were not going to fix it straight away. i didnt meant it so serious as it sounded though i just wanted to grab peoples attention and get some advice on how to handle it
Anyway Good news Hargroves are replacing the bicycle
happy after hearing they might not do anything about it on saturday for them to replace the bike today.
and never made or had any intention of legal action but would have been nice to know where he stood if they didnt sort it out
That's not true with the kind of cheap QR pictured. The lever that sticks out of the side of the end cap HAS got enough movement to double back on itself (and stick in a disc and then finish under the fork as pictured). I've a bike with that kind of QR in the garage and I've just been in to open it. You can even see the curve of the lever in the picture above.
That's shocking then. I've got Mailard, Campagnolo, Shimano, Mavic, Alex, DT Swiss, Bontrager and even a Quando and none of them can open or close enough to get anywhere near the spokes or disc. Hard as you try they won't get near.
Yep good news, well done hargroves
Ready to burn the lot of them yesterday and now they're getting congratulated...
Madness. This thread should just be deleted.
This thread should just be deleted
Agreed
Guy has an accident, could be fault of shop, could be fault of rider.
Complaint made to shop, 2 days later, they agree to replace bike, seems top notch service to me.
Where is the story?
