Topic starter
Any tips for making spacers for transporting a road bike in a box to stop crush damage?
Posted : 02/06/2018 8:01 pm
Rigid plastic or copper water pipe cut to slightly longer than the dropout width and held in place with the original skewers.
Posted : 02/06/2018 9:21 pm
Copper or HDPE plastic pipe, couple of 5 or 6mm 'penny' washers each end on the inboard sides if using copper as it can scratch / mark the inside of the drop-out.
Posted : 02/06/2018 9:29 pm
block of wood cut to size? chunk of studding?
Posted : 02/06/2018 9:31 pm
Ask your LBS for a couple of these:
Posted : 02/06/2018 9:35 pm
Topic starter
Excellent advice, success!
Posted : 16/06/2018 2:20 pm
Blimey that's impressive.
Posted : 16/06/2018 2:25 pm