Topic starter
Anyone happen to know if a QR bolt from a normal seat clamp collar will do the job for a frame with an integrated seat clamp? Or is a special length of bolt needed or specially shaped QR lever required?
Secondly, anyone know of anyone other than Hope that make/sell those little bolts that screw into the v-brake bosses on frames and act as a guide for the disc brake hose? The hope one's are a bit OTT for my needs - an old bike I had had a little plastic loop thing that held the hose in place.
Many thanks in advance.
Posted : 13/04/2009 9:01 pm
If the clamping faces are flat then a nut bolt and washers will be fine(they usually are).
Try either a car spares shop or electrical wholesaler for P-clips.
Posted : 14/04/2009 7:26 am