Ok I thought I’d have a crack at building a wheel, I have some lovely dt competition spokes with 14mm brass nipples from crc, I am presuming dt Swiss nipples. Everywhere I read says that I should use the black park spoke wrench 3.23mm but it just doesn’t fit, too tight to go over the nipple. I went for the 4 sided wrench. So do I have big nipples??!!!? A small wrench or just been misinformed and purchased the wrong one?

(and no this thread wasn’t just so I could type nipples so much)

Right wrench wrong nipples they can’t be dt nipples.

Bugger!

Thanks