Absolutely go with brass, especially if it's for a commuter bike subject to year round weather.
I can't recall the last time that I had a brass nipple fail on me, they're reliably reusable.
VW cars are sold for many reasons, emissions is not one of them, at least it wasn’t.
People didn't look at emissions when buying cars? Really?
Sapim on the other hand only make spokes and nipples. They’ve made a categorical claim about 50% of their product range – alloy ones won’t corrode
Aluminium spoke aren't 50% of their product range.
and it would be very obvious if they turned out to be lying.
The fact that an enthusiast forum is arguing about this says it wouldn't be obvious at all - it's not like there's a database is stats.
Both were absolutely fine. One did not get much use, the other was my main MTB for a decade or so. I say fine – the wheels were a bit flexible in proper rough stuff, but then lots of stuff was back in those days.
"Fine" as in all moved freely after that decade, having been ridden year round, like the OP who has worn out a rim, the conditions are so rough?
Enjoying the discussion, you never back down with me!
“Fine” as in all moved freely after that decade, having been ridden year round, like the OP who has worn out a rim, the conditions are so rough?
No, on a fairly well looked after (but not obsessively so) bike.
If you go back to the start I said brass for everything except where you care about weight and want a lightweight build on something you are going to clean. And I will now be going with Sapim for those cases, as a considered risk. End of thread, at least from me.
I had to cut the spokes out of a wheel I'd built using sapim aluminium nipples when I went to change the rim after 3 years. Have never had to do that with brass nipples.
