Shock wiz calibrati...
 

Subscribe now and choose from over 30 free gifts worth up to £49 - Plus get £25 to spend in our shop

[Closed] Shock wiz calibration.

20 Posts
12 Users
0 Reactions
101 Views
Posts: 3029
Free Member
Topic starter
 

Trying calibrated front pike forks. If I completely empty them of air I cannot extend to full travel...
Any suggestions?
San I run them with 5 psi in, or does that knacker the calibration/?


 
Posted : 04/11/2019 8:16 pm
Posts: 28712
Full Member
 

Leaving a little bit in gas never been an issue in my practice. Sometimes it can come down to weird little things like that depending on the forks.


 
Posted : 04/11/2019 8:20 pm
Posts: 3029
Free Member
Topic starter
 

Managed it with about 8 psi in...


 
Posted : 04/11/2019 8:46 pm
Posts: 14648
Free Member
 

mtfu or is it ptfu nowadays?
Though I remember standing on my the rim of front wheel, while trying to drag the front end up, was a lot of fun on rev's.

PS: I got a ratio of 2.2 IIRC


 
Posted : 04/11/2019 8:53 pm
Posts: 3029
Free Member
Topic starter
 

2.1 on 130 pikes ....


 
Posted : 04/11/2019 9:21 pm
Posts: 233
Free Member
 

2.5 on 150 Pikes


 
Posted : 06/11/2019 1:38 pm
Posts: 233
Free Member
 

It would helpful if RS published this information.


 
Posted : 06/11/2019 1:39 pm
Posts: 0
Free Member
 

well, ratio also does depend how many spacer you are running, not just length of travel.


 
Posted : 06/11/2019 2:29 pm
Posts: 3029
Free Member
Topic starter
 

And interestingly RS don't ....
Might also be helpful in Shock Wiz did as well
Obviously, spacers will make a difference ...


 
Posted : 06/11/2019 2:39 pm
Posts: 5304
Full Member
 

A database would be useful.
2.5 on 150mm Yaris.
2.6 on 160mm Yaris.


 
Posted : 06/11/2019 3:15 pm
Posts: 0
Free Member
 

doomanic

Subscriber
A database would be useful.
2.5 on 150mm Yaris.
2.6 on 160mm Yaris.

Toyota? 😆


 
Posted : 06/11/2019 4:24 pm
Posts: 3029
Free Member
Topic starter
 

2.2 on Pikes now at 140mm ...


 
Posted : 20/04/2020 9:42 am
Posts: 0
Free Member
 

A database would be useful.

well, ratio also does depend how many spacer you are running, not just length of travel.


 
Posted : 20/04/2020 9:49 am
Posts: 1079
Full Member
 

And the version of the air shaft.

2017 Pike, upgraded air shaft, no tokens 4.9 !

Is my Shock Wiz knackered ?

About 50 psi but shockwiz says 9.7 psi 🙁


 
Posted : 20/04/2020 2:38 pm
Posts: 1731
Free Member
 

Mine has a solid red led and wont connect, any ideas?


 
Posted : 20/04/2020 2:43 pm
Posts: 0
Full Member
 

Think I had this on mine and it turned out to be a flat battery.


 
Posted : 20/04/2020 5:21 pm
Posts: 1731
Free Member
 

Think I had this on mine and it turned out to be a flat battery.

Tried about 8 include 4 new ones out the packet.


 
Posted : 20/04/2020 6:03 pm
Posts: 3029
Free Member
Topic starter
 

TBH - I would send it back to SRAM. They were very keen to replace mine.
That said - I am not too sure how much value it really has ..


 
Posted : 20/04/2020 7:41 pm
Posts: 1731
Free Member
 

TBH – I would send it back to SRAM. They were very keen to replace mine.
That said – I am not too sure how much value it really has ..

Can you send them direct or does it have to go back to the seller, in this case bike discount?


 
Posted : 20/04/2020 8:00 pm
Posts: 3029
Free Member
Topic starter
 

Have to go back in to the seller. But I did talk with Shock Wiz / SRAM directly


 
Posted : 22/07/2020 12:35 pm
Posts: 0
Free Member
 

what brand of battery are you using? I'm pretty sure they dont play nicely with Energizer or Duracell batteries for some reason - mine works fine with Panasonic batteries, but a brand new Energizer doesnt work at all.


 
Posted : 22/07/2020 1:33 pm