Bike Forum
5
Posts
3
Users
0
Reactions
50
Views
Topic starter
my current seatclamp sits higher than the frame by a few mm. Not noticed any issue yet, but i cant decide wether or not long term useage could casue an issue. I dont want to crimp the frame or even worse, snap it. It is a carbon frame...
what do you reckon stw?
Posted : 07/12/2014 6:22 pm
Can you get it in the right place by pulling the clamp open a touch while you put it on? I have to do that to fit my seat clamp on fully, it won't just slide on.
Posted : 07/12/2014 6:41 pm
Topic starter
nah, there's only a small amount of tube that's available to clamp...so i'd have to get a very low profile seatclamp
Posted : 07/12/2014 6:48 pm
I wouldn't be happy with that set up , there must be a seat clamp that fits properly .
Posted : 07/12/2014 6:50 pm
Ah ok, for all they cost I'd get one that fits.
Posted : 07/12/2014 6:51 pm
Topic starter
aye, i didnt realise to be honest, 2nd hand frame.
Posted : 07/12/2014 6:52 pm