[Closed] Little plastic rings that come with Shimano disc brakes

They clip on to the caliper mounting bolts to dtop them loosening.

I thought they were clip-on hose guides - put them over the hose and stick the prongs into the existing cable stops.

They clip on to the caliper mounting bolts to dtop them loosening.

+1

Just how much of a problem is caliper bolt loosening in the real world? About as much as the problem of rotor bolt loosening that those little metal tabs are meant to solve?

(Cards on the table time - first ride on a new-build hardtail last week and after a few miles I had a rubbing noise from the back. Stopped and found I'd forgotten to tighten up the rear caliper... or had it come undone???)

I'd never have guessed that in a million years, ta.

Just how much of a problem is caliper bolt loosening in the real world?

I wondered that, also with the split pin for the brake pads. I remember a time when men were men and bolts were bolts and you didn't need any of these funny new fangled bobbins to keep your doohickies attached to your wotnots.

I'd never have guessed that in a million years, ta.

You want to be reading the instructions then!

I wondered that, also with the split pin for the brake pads. I remember a time when men were men and bolts were bolts and you didn't need any of these funny new fangled bobbins to keep your doohickies attached to your wotnots.

Well my car (1976, but the brakes used had't changed since the 50's) has a big metal shim that has to be bent over the bolt heads. Plastic clips or even wire would have made life easier.

Look at the wheel nuts on a lorry/bus, those plastic tabs are to show if the nuts have moved.

Just how much of a problem is caliper bolt loosening in the real world? About as much as the problem of rotor bolt loosening that those little metal tabs are meant to solve?