Topic starter
I’ve got a new bike and it comes with a fox transfer dropper. The lever has been fitted on the right, above the bars and is a bit numb where it is but has a nice smooth cable run into the port on the left hand down tube.
I’m wondering with moving it to under the bars on the left but the cable might be too tight to go back into the same hole. There aren’t any other holes for the dropper to enter the frame.
Before I start cutting cables, is this likely to work?
Posted : 16/02/2018 9:20 pm
It'll probably be ok anyway but if not fit a noodle of some type?
Posted : 16/02/2018 11:28 pm