Like this: http://www.chainreactioncycles.com/Models.aspx?ModelID=13735
to put my IS Hope caliper on a Marzocchi PM fork.
Except this one says it doesn't fit Marzocchi forks - anyone know one that does work?
Thanks
I think I may have to see one of those on the flesh. It says red but it looks more fuschia to me.
That mount from CRC works with a little modification. I used to have some mx pros and used that with my shimano is caliper.
Cant remember which end it was, but you just have to file a bit off the corner of one if the square bits which bolt to the fork itself. Fits fine then.
[url= 
]Picture 1[/url]
[url= 
]Picture 2[/url]
The kcnc one is red (disappointingly) in real life... Got one last week.
That mount from CRC works with a little modification.
Ta - I'm not averse to a bit of home bodgery.
The Hope one will work.
Used one to fit Giant MPH IS disc caliper to some PM MX-Pros on Friday evening.
Took a wee bit to work out why rotor rubbing.
Therefore file was needed - did not align properly with the PM mount until a little bit of the corner filed away.