Topic starter
I've just been removing the bearings from my old Turner prior to powder coating but I've no idea how to remove the grease port nipples. Has anyone else had an isse with this and if so is there a way round it?
Ta
Posted : 10/04/2011 3:52 pm
Topic starter
A no then?
Posted : 10/04/2011 5:55 pm
They're a push fit on older HL frames, don't know if that's changed.
One way to get them to pop out would be to pump grease in faster than it can get out past the seals, but I'm guessing you're past that method...
Posted : 10/04/2011 5:59 pm
Email Greg at Turner, they'll let you know.
Posted : 10/04/2011 6:13 pm
Old ones, a sharp blade and work them out, new ones are threaded and unscrew
Posted : 10/04/2011 6:16 pm
like coogan says try greg at turner or the turner forum on mtbr. they have a wealth of useful info on there and it's rare that you get a 'what tyre' thread!
Posted : 10/04/2011 6:22 pm