I’ve got the 2011/12 26” version of the above, play is developing in the bearings so I’ve opened it up to find out which I’ll need. Got the end caps off, bearings visible so that’s fine; I can order what I need. Problem being, I’m not sure what I need to do next. I can’t see how I’d get the bearings out. I assume there’s a good chance I’ll need some sort of bearing puller, but the axle tube that they all interface on is in the way.
Anyone got any experience with them, or can point out what my Sunday brain is missing?
Have you tried this?
It's from the Crank Brothers website support section. Presumably being IODINE 3 they're the same hubs......
Thanks for this! I'd sort of given up hope on a reply. The wheel is currently sat waiting for me to get time for another go at it so I've saved the document for reference.