[Closed] Carbon fibre safe glue/adhesive

Most double sided tape would be fine. Or two part epoxy if you never want to remove it.

Two part epoxy will be fine, e.g. this

https://www.toolstation.com/shop/p80659?r=googleshopping&rr=marin&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gclid=Cj0KCQjwuuHdBRCvARIsAELQRQF9XacCNw3H15qDCeDI1vLGyw48---Y-cX7XUPGS1kE9qu1U1Dw0a0aAl6GEALw_wcB

Why believe me? I spent several years deisinging and making composite tubes, I use two part epoxy to fix bikes based on this and have never had an issue.

Edit: try and remove some mystery span formatting.

Thanks very much chaps.

I might use both actually, see how I get on with some good double sided, incase I do ever need to remove it (for invisiframe replacement maybe) and if that doesn't last, I'll give the two part epoxy a go.

I take it any form of double sided tape, like number plate adhesive tape will be safe?

Just make sure it's as clean as you can get it. Allow it a good time to dry if you're wet cleaning.

I used epoxy on mine but definitely did not want it to come off.

The downturn barrel adjuster seized. It was riveted on, so I took the bold step of drilling the rivets out, then I was able to free up and replace the adjuster, and I glued it back on. Has been solid for about 7 years.