just got a pair of SLX brakes in the post, for £130. crc now saying that the product code is now unavailable, so don't have the page for them.
anyway, planned to fit them as i'm doing devils staircase etc tomorrow, and my current brakes are gash. opened the SLXs, to find that the levers are the opposite way round (LH front, RH rear) - nothing at all mentioned on the CRC site when i bought them.
can i swap the levers round, without having to buy new olives etc - obviously impossible before tomorrow morning.
alternatively, i guess i could just run the levers upside down for tomorrow...
grrrr...
Just swap them over. If you're careful, you won't even need to bleed them. Definitely don't need olives, etc.
aye, i knoew i'll have to swap them 🙁
would have been nice to have been told, i'd not have been bothered about spending an extra £4 on them at the time.
definitely won't need new olives etc though? and how will i get the barb out of the hose, if i want to shorten them ?
dont bother shortening them if you want to ride tomorrow
remove pads , squeeze lever out to push pistons out about half way.
leave top cap in place
remove hoses swap over - tighten them up
remove top cap
push pistons back
air will escape - top up the reservoir
coil up excess hose zip tie - go ride
buy new barbs and olives and shorten at later date
to stuff terry 😀
i assume it worked for you 😉
its hella easy to push the pistons too far - was expecting a reply along the lines of "you **** i have broken them now need to bleed them "