Help,
Just replacing rings on shimano xt crankset, only to realise it requires Torx key. Can somebody advise size required?
I suspect it is a 3.0 / 30?
Thanks , in advance.
Sniff
I would just get a pocket multi-tool, or a bit set. Bound to need another at some point! No one buys single hex keys, right?
T-30
But buy a set as above.
They are better. You'll be glad you did.
🙂
T-30...Thanks Chaps!
I think, for removing chain ring bolts, I'll get a nice quality single hex key.
Sniff.
Good quality Y wrench with torx is handy for this...
https://www.merlincycles.com/pedros-y-torx-t10-t25-t30-torx-tool-90167.html?utm_campaign=googlebase-GB&utm_source=googlebase&utm_medium=shopping&utm_term=Workshop+Tools&ucpo=31581&gclid=COTnmdicvNECFRS6GwodIcYAHw
Sniff.
ru ok hun?
🙂
as trailrat the multicoloured wera torx // allen keys are superb, costly but can feel the quality.
Don't get tamperproof ones...they snap more easily. I found that out by being lazy and using one that was drilled for the security pin 🙂
I have a (couple of sets) of loose keys in varying quality and some nice socketed ones in specific (useful to me) sizes for use with tommy bars / torque wrenches etc
I'm all for hex, allens round too easily.