Forum menu
3L Resevoirs
 

[Closed] 3L Resevoirs

Posts: 2
Free Member
Topic starter
 
[#1289261]

I need a new one for my Camelback is there anything better than an Omega one, or should I go for something else?


 
Posted : 03/02/2010 4:55 pm
Posts: 2
Free Member
Topic starter
 

anyone use these?
http://www.gooutdoors.co.uk/platypus-hoser-3-hydration-bladder-p126454


 
Posted : 03/02/2010 4:58 pm
Posts: 4
Free Member
 

Find the dakine/hydrapak bladder really good, only thing letting it down is the bite valve imo, its a slide in/out design and leaks if left out, found the slide gets really hard to pull out to the point where I think i'm going to pull teeth out with it, if only the camelbak bitevalve would fit....


 
Posted : 03/02/2010 5:03 pm
Posts: 7283
Full Member
 

I do know that Omega resevoirs are not microwavable. I keep my bladder in the freezer so no bugs grow in it . I wanted to go out for a spin and it had a block of ice in the tube and about a pint in the bladder, so i pop it in the microwave . 'fail' . I melted the bladder. Looked at a new Camalbak one and they seem to be £22 ish, so I bought a cheapo 2.5 ltr one from Ebay , which still tastes like anti septic , even after half a dozen soaks in freash water. It also doesnt seal very well and the thread on the tube has stripped already so it permanently weeps .
I like the look of the Platypus one, I had one years ago and it lasted maybe 5 years ( no microwaving tho )


 
Posted : 03/02/2010 7:11 pm
Posts: 4337
Full Member
 

The ones from Deuter are much easier to fill, clean and are very robust.

They have just introduced a new valve as well with a twist to open/lock action.

Thoroughly recommended.


 
Posted : 03/02/2010 7:31 pm
 jedi
Posts: 10249
Full Member
 

dakine. fill with ice cubes easily in the summer too


 
Posted : 03/02/2010 7:32 pm
Posts: 0
Free Member
 

Really like the Hydrapak bladders.
Bitevalve is good and easier to clean than camelbak.


 
Posted : 03/02/2010 7:42 pm
Posts: 0
Free Member
 

Think I will go for a Platapus one 🙂 thanks all.


 
Posted : 03/02/2010 7:57 pm