Topic starter
Need a bit of advice, please. Should the seatpost go lower than in the pic? There is a very small "tab" of metal that stops the post going any further down... Is this norm or just an incorrectly finished weld?
Cheers all.
[img] 
[/img]
T
Posted : 20/02/2010 5:10 pm
Normal. I filed mine off and run it a little lower to give me a bit more range. Go careful, especially if you have an air shock
Posted : 20/02/2010 5:12 pm
Yep it's normal, it's to stop stupid people smashing the shock with the seatpost.
Posted : 20/02/2010 5:53 pm
i can see a disaster looming.
Posted : 20/02/2010 5:55 pm
I cut about 70mm off my post so I could drop it a bit more, at full height it just goes past the safety hole too.
Posted : 20/02/2010 6:47 pm
normal. I cut down the post.
Posted : 20/02/2010 6:54 pm
Topic starter
Good stuff - cheers everyone.
T
Posted : 20/02/2010 7:43 pm