Do they all use the same spline?

Will this fit on an Alfine hub?

Do they all use the same spline?

NO, the original Saint had an oversized spline, but everything else does.

Will this fit on an Alfine hub?

Yup, indeed it will… Though what size you after Stu, may have a spare unused 160mm XTR rotor kicking about somewhere if you wanted it.

Ta. I had it in the back of my mind that one of them was different.

Just couldn't remember which one.

A 160 would be cool for the right price mate. 😉

Yes, but your normal cassette lockring tool won't be able to fit it 🙂

A 160 would be cool for the right price mate.

I shall see if I can find it then!

Sam – Member

Yes, but your normal cassette lockring tool won't be able to fit it

Why's that then Sam?

I bet I can "adapt" one. 😉

it wont be deep enough.
ice tools do a deep one.
i just sold a alfine to a guy from the black country. 🙄

it wont be deep enough.

I'll cut the top off an old one then.

You might have sold one but not to me though.

not yet

mboy.

Any luck finding the rotor?

A 160 rotor won't stop a lard arse like you

A 160 rotor won't stop a lard arse like you

In that case I'll be leaving you even further behind then won't I.

In that case I'll be leaving you even further behind then won't I.

Yeah………….Like OK 😉

wanna buy a set of bb7 with 200mm rotors funnybikebloke?

wanna buy a set of bb7 with 200mm rotors funnybikebloke?

I think the 'tolla needs bigger rotors than that to stop his kingsized wok.

Only need the 200mm when your ego jumps on for a ride 'splosion

nice powerfull bb7 to stop the mass of your new wheel…. 😉

😉 @ wokboy

mboy.

Any luck finding the rotor?

Not yet, pretty sure i put it away in a box somewhere. I'll dig it out tonight…

I bet you put it somewhere safe…..