Chat Forum
4
Posts
2
Users
0
Reactions
27
Views
Topic starter
Any thoughts on how to get this pin out on a Hammer based garden chipper.
I was hoping to reverse the hammers and mayby replace the axle spacer collars.
Just bash it ?
More pix here.
Gallery
https://www.sidingstudios.com/2021/11/07/ready-to-shready/
Thanks RT
Posted : 07/11/2021 11:38 am
Looks like it, as long as you can get a punch in you should be fine. Does the shaft not rotate at all for better access?
Posted : 07/11/2021 11:56 am
Topic starter
Shaft rotates. Thanks for the response.
However, in the last few minutes the instructiond have been found.
All is needed 3/16 pinch and make sure you bash the end with no groove when removing the so call "Groove Pin".
American machine.
Posted : 07/11/2021 12:01 pm
Topic starter
Sorted.
Posted : 07/11/2021 12:07 pm
Cool, never seen a pin like that, just assumed it was a normal split pin.
Posted : 07/11/2021 4:16 pm
