Hope Pro 2 QR + XD driver = binding? - Singletrack World Magazine September 27, 2015

Overview Chat Bike Members News Women

This topic has 2 replies, 2 voices, and was last updated 8 years ago by frogstomp.

Viewing 3 posts - 1 through 3 (of 3 total)

Hope Pro 2 QR + XD driver = binding?
frogstomp
Full Member

I have a Hope Pro 2 rear hub (converted to Evo spec some time ago) which I have been running XX1/XD with 12mm axle using the appropriate XD-specific end cap. All is fine..

I’ve just tried to switch the end caps to QR and when I tighten down the cassette it appears to bottom out on the D/S end cap, stopping it from spinning. I have tried both with and without the 2mm spacer but it makes no difference.

Any ideas? I can’t see an XD-specific end cap for QR like there is for 12mm..?

Posted 8 years ago

Rorschach
Free Member

http://www.jejamescycles.co.uk/hope-pro-2-evo-xx1-xd-qr-drive-side-spacer-135mm-id83626.html

Posted 8 years ago

frogstomp
Full Member

Cheers!

Posted 8 years ago

Fresh Goods Friday 703 - The Mushroom ASMR Edition

Viewing 3 posts - 1 through 3 (of 3 total)

The topic ‘Hope Pro 2 QR + XD driver = binding?’ is closed to new replies.

Overview Chat Bike Members News Women