I asked this question a long time ago with no further information coming up !
has anyone rebuilt the rear wheel on a genesis io singlespeed ?
its the standard wheel sealed bearings but i can’t find any info anywhere ?

any help appreciated

What is your question caller?

how do you get the bearings out

I think it’s the same hub I had on my SS a couple of years ago – The generic On-One/ Planet X/ everyone else hub. It certainly looks identical anyway!

If it is I seem to remember it was just a case of removing the bearing end caps off the axle, then tapping the axle with a hammer until the cartridges fall out, then tapping new ones in with an appropriately sized socket

I remember I didn’t have to remove the freewheel, either, and therat there’s only 2 bearings in there….

2 is good ….
what did you replace them with skf from bearing supplier ?

They are standard bearings from an engineering supplier, you’ll see the ref no. on the seals when yuo get them out.

*Watches* i have to do this too.