Topic starter
What's the best practice when cutting a bath panel for a nice clean edge and preventing loss of fingers? Fine tooth saw, stanley knife, jigsaw? I have clamps and straight edges to assist.
Advice / experience welcome before the usual "measure twice, cut once"
Posted : 10/06/2019 5:35 pm
What's it made from?
Posted : 10/06/2019 5:37 pm
Topic starter
What’s it made from?
Whoops that would help...
Usual white plastic, not a cheap thin one though, hence the check before I cut it.
Posted : 10/06/2019 6:20 pm
This would be my weapon of choice: https://www.screwfix.com/p/irwin-pullsaw-7-185mm/5797x Cuts thin plastic nicely. Doesn't stress the material.
Posted : 10/06/2019 6:26 pm