Being a recent convert to 1 x 10 on my Santa Cruz Blur LTc,
i now 'need' a chain retention device and bash guard that'll fit.
It'll have to be BB mount (no ICSG tabs) and i remember reading about some issues with some devices.
Any input from da STW massive??
I have an E-Thirteen LG1 Tr. Works perfectly. No bash.
this is the one i had on my BLTc but nearly all single ring BB mount devices should be fine.
the chain device problems on the blur's occur when you want to use a 2x10 chain device like the e thirteen TRS+ they hit the chainstay because the bottom link is so low.
I've been using the BB mount E-13 XCX on my Blur Trc has been fine so far with the XTR + rear mech.. 🙂
Same fitting issue as my old NomadC. The lower VPP link & dropped chainstay get in the way of the guide.
The wider MRP that was made for the Mojo HD reportedly fits without fouling. All the E13's I tried you could fit them, but never in the right position. Maybe the new LG1 Trail has a wider fitment to allow it fit properly.
The only one I found that fitted properly was the Straitline Silent Guide. Which incidently is the best guide i've used to date.
The only one I found that fitted properly was the Straitline Silent Guide
ISCG only though isn't it?
Not sure to be honest, as the Nomad had tabs - but not an issue anyway - Blur uses a normal BB, so can just use a BB mounted ISCG adapter to mount it with 🙂
Thanks folks.