Topic starter
Thinking of buying a 10 speed Zee rear mech with the clutch and then combining this with my SRAM 9 speed shifters.
Are there any updates on the size of the spacer required to change the pull ratio of the mech to the same as the shifter?
Thanks.
Posted : 14/05/2013 7:50 pm
Need to measure my final version, can't remember 😳
Posted : 14/05/2013 7:53 pm
Topic starter
Thanks.
From what I've read, people buy a 0.25" (6.35mm) square nut and cut a groove for the cable with a final height of 6mm. But I'm not sure if this provides the perfect change in the pull ratio.
Posted : 14/05/2013 8:03 pm
Topic starter
Bump 😉
Posted : 16/05/2013 6:53 pm