Topic starter
Hi All,
So the pivot maintenance saga continues. Pivots disassembled, bearings replaced using new RRP bearing press and ready to put back together. However, it is really difficult to re-assemble and I am now worried that the washers might be in incorrectly. Now, I have taken it to bits several times before but I am still worried.
Does anyone have a diagram or can anyone tell me which way round the red washers go?
Many thanks as always
Dogsby
Posted : 22/08/2017 8:02 pm
Topic starter
I really just need some advice as to which way round the red washers go. Currently they are positioned with the flange innermost.
Any help would be appreciated.
Dogsby
Posted : 22/08/2017 9:29 pm