If I was to want some new dropouts welding to my ti frame, where would be a good place to it done?
Vernon Barker has come up on a few searches, but the website doesn't seem to be working - does the business still exist?
Enigma would be a good choice.
I've read some less than complimentary (complementary?) things about Vernon Barker on here recently.
email sent to Jim and Mark at Enigma.
Thanks.
cynic-al could probably set you up with some duck tape, coat it in carbon and send you out on it! 😉
Nicko74 - A spoon would be needed too
You've found the source of the creaking? 😮
You've found the source of the creaking?
ahem, that was a chainring bolt 😳
this is an idea of merging my bikes, if you get my drift... 💡
VB's site only works in ie. The general consensus is he's really good with steel & alu but not very neat with ti
Is this the Djab your modifying?
What you thinking?
belt-drive....
Will you be selling the Kona then ..........
maybe. 🙁
barely ridden it since I got the centre-track. But space at home is going to be an issue in the near future as the baby-buggy will be re-appearing from the loft.
Alternative idea is to put the Rohly and other gubbins on the Kona. but I really, really like the Voodoo.
If you did decide to part with the Kona ( 🙁 ) could you let me know?
Mmm. Hacking apart ti frames... 😀