7 weeks and 400 miles old. Now mangled foil and useless
Can't say I have had that problem.
mine are fine
No issues with mines ether
I had loads of the old ones break but not the new "half sized" ones... And tbf I'd expect to have broken at least a couple by this time if they were as bad as the old design.
did you replace the DS seal when swapping the springs?
Mdy bike is my only mtb and it gets very wet, also wonder if single ring may be something to do with it
did you replace the DS seal when swapping the springs?
Yup
Mdy bike is my only mtb and it gets very wet, also wonder if single ring may be something to do with it
I doubt it. It's the same set up for SS hubs too, they should see a lot more stress IMO.
In the 400 (wet) miles have you popped off the hub body to give it a clean?
I christening my new Hope SS hub at the 'puffer this year. Popped off the hub body when I was the bike a clean and it was fairly manky in there, not gritty just grey horrible-ness. I think it would of been fine but a quick wipe and a drop of fresh lube and its purring again.
That was what I did today, 400 miles is not much
Rob, I've got about 7000 miles on mine, all single ring & its me only bike & we ride the same places. Do you pack the hub with loads of grease?
No problem whatsoever in thousands of miles, which is more than I got with the standard Pro 2's. Have you just replaced them?