[Closed] Helmets - not a do you or don't you thread but when you...

around 5 years, mine should have been replaced by now but I've yet to locate one I like or fit my bod
(eyeing up the new Bell super thanks to a thread yesterday)

Why? Because I only have one head and the skull isn't very thick.. & everything degrades and all those low branches will have taken their toll.

Not to hijack, but I've just been having similar thoughts. Trail helmet's had all the usual wee knocks you describe, then I decided to exit my bike by the front door at the weekend and put some nice scrapes down the side with a bit of a dent for good measure. Probably should replace but......

I used to change every three years on the basis of progressive UV degradation. After a bit of thought, I bought a helmet with a material that is uv stable, and I plan on. Keeping it until it takes a decent knock.

Changed mine last week after 6 years of use. The integrity of the shell showed no outward sign of fatigue, but the pads and adjustment system had rotted away and detached from the foam liner.

I replace mine when I find a crack in them, which is usaually 2-3yrs.

When it starts to make my forehead itchy.

When it starts to make my forehead itchy.

Should get a new one I guess.

5 or so years for me. It may or may not make a difference but I don't intend to find out!

Cheers

Danny B

I binned a few of my family's one that were all around 5 years old. Partly as an experiment and partly to make sure no one was wearing a helmet that I didn't consider safe (well that was why I was binning them) i put a lump hammer through them.
Two were pretty tough, took a few blows to break them. One the lump hammer went through like compressed sawdust - seemed perfectly solid until it was struck and then just disintegrated without any noticeable resistance to the hammer.
It wasn't the oldest of he three, nor was it the most used.
Don't know exactly what that proves other than not everything ages at the same rate.

Now I'm thinking about all the branch strikes the helmets had.....

Might be time to replace.

Two were pretty tough, took a few blows to break them. One the lump hammer went through like compressed sawdust - seemed perfectly solid until it was struck and then just disintegrated without any noticeable resistance to the hammer.
It wasn't the oldest of he three, nor was it the most used.
Don't know exactly what that proves other than not everything ages at the same rate.

Don't have to prove anything, you don't need an excuse for smashing stuff with a hammer.

Meh. Went out last week with a 20 year old helmet on, I'll wear one to make other folk feel comfy, but I don't believe in them.

[img] [/img]

I've got 4 or 5, from various different times...

I could get all technical and hit it with a hammer but my philosophy is... if it stinks get a new one.

No one likes a smelly helmet.

I have a story about this very thing.

My old boss was (and still is) a true English gent. I never heard him swear or get even slightly angry.

Now, working as a civil engineer, he was frequently on site, wearing PPE.

On this particular occasion, he attended a site meeting on an active site on the Tyne.

What I have subsequently found out is that safety helmets have a duration. There are two round 'stamps' on the inside which date the manufacture of the helmet and that they have a 'shelf life' due to degradation of the plastic.

Anyway, back on topic, we were discussing this when my boss walked over and announced that 'He had just had his helmet inspected down the quay' resulted in fits of stifled laughter.

i had a 4 year old TSG pisspot that had taken a few small blows.Replaced it with another and dropped the old one from 30 foot to concrete to test it. Just bounced and seemed fine - Although the inner seperated slightly from the outer shell.Plus UV exposure would affect things negatively too

**The drop occured on private land I should add** with no risk to anyone.

Normal XC helmets wouldn't be so robust though and are more likely to need replacing more often with fewer smaller impacts IMHO.

Replaced it with another and dropped the old one from 30 foot to concrete to test it. Just bounced and seemed fine.

You need weight acting inside the helmet to simulate the crash situation. Now go do it with a 70kg weight inside and see how it does 😉

when my boss walked over and announced that 'He had just had his helmet inspected down the quay' resulted in fits of stifled laughter

*queue bevis and butthead style laughing* 😀

true. 🙂 Might make sense to store them in a bag or dark really as long as the temperature is reasonable.

I bought a new one when the boss at my LBS saw mine (I was looking at gloves and full-face helmets at the time) and said, "mate, you can't wear that, it's knackered!" I guess I hadn't noticed quite how many dings and cracks and scrapes it had acquired, from a few crashes and a lot of low branches...

I follow a policy of replacing mine once they look scarily smashed up. Any time I feel like getting a new one, I just arrange for my bike to fall on my head.

I bought a helmet with a material that is uv stable

Are you going to give us any hints, or just leave us to guess?

The obvious answer though is to not wear a helmet - nothing to go wrong in that case.

I'll wear one to make other folk feel comfy, but I don't believe in them.

You know it's all placebo effect? So wearing a helmet won't do you any good at all.

I replace my helmet when I can no longer stand the smell coming from it, usually after around 2 to 3 years.

I replaced my yesterday, got a giro hex for the bargain price of £29! Last years colours apparently. My old one died this week from a relatively light bump on a low branch. Was initially annoyed as impact was gentle, then worked out it was 12 years old!

I just make sure my helmet gets a regular inspection from an independent expert.

Is that expensive, Jon Taylor?

Sounds like fun.

giro recommend replacement every 3 years to go in line with their crash replacement warranty...
my last one was a giro xen that is now 7 years old but still looks to be in good condition, but with UV degradation and of course the elements and my sweat, i wouldnt like to test its structural strength with crashing it..
its not always about what damage you can see on the surface but more a case of what's going on under it...minor knocks to the shell over time could lead to a major failure waiting to happen, but you'll never know you cant tell what damage is taking place to the foam under the outer shell...
at my last place of work we had a fleet of bikes that were bought in the early 90's along with helmets...fast forward 12 years and they were still there, and i had to justify their replacement so i got a few of the helmets to demonstrate to the boss how unsafe they were. first one was a bit tougher than i expected but the second one just disintegrated when i stuck it in a headlock type hold and gave it a squeeze...
boss then told me to condemn the whole lot and told me to do what it takes to secure funding for replacements...
£16k worth of bikes and equipment later he was a happy man!!

I replace mine every 3 years or so. Materials degrade and constant little blows you may not notice too much or easily forget about out on the trails soon add-up.

I value my head, I'd like to keep it intact for as long as possible, so I value my helmet.

I have a Grio Xen that is 5 years old that I've "replaced" with a TLD A1 after some spectactular upselling by a shop owner in the US. I didn't change the Xen because it was old, I just wanted a spare lid for when people visit me and this guy sold me quite nicely on getting this one.

I replace my helmet when the pads get worn or the helmet gets uncomfortable. If I whacked it hard in a fall, I'd probably change it too, but luckily that hasn't happened yet. I've had falls, but not on the noggin.

So I'm getting back on the horse after a few years. I'm pretty sure my RF-200 that I was using back when I was riding on a regular, will need to be trashed and replaced. However, I purchased another RF-200 around the same time as my primary, when needed for a secondary rider. That one was used a few times, but mostly stayed in a bag on a shelf in a closet all this time. I'm thinking of using that for the time being till I decide to get another helmet. I've had people tell me it'll be fine, others say I should replace it (due to the 5 year rule). It's never been dropped, no dings, no scratches, doesn't smell. Practically brand new. However, the foam liner at the top has started to deteriorate. I wore it for go-karting last week, and the sweat from my head made the liner start crumbling off. Not much, but still crumbled. Should I have any concerns about this helmet? I love this helmet, fits my head like a glove...still. If it's still good to use, I'd prefer to use it for a while longer.

i tend to change mine when i change the bike, first was red n black to match, second green to match, 3rd bronze to match, . . .

oh ow,....im still on bronze with my newest one . .

time to change, white, black, dark grey or cyan should do it

So I'm getting back on the horse after a few years. I'm pretty sure my RF-200 that I was using back when I was riding on a regular, will need to be trashed and replaced. However, I purchased another RF-200 around the same time as my primary, when needed for a secondary rider. That one was used a few times, but mostly stayed in a bag on a shelf in a closet all this time. I'm thinking of using that for the time being till I decide to get another helmet. I've had people tell me it'll be fine, others say I should replace it (due to the 5 year rule). It's never been dropped, no dings, no scratches, doesn't smell. Practically brand new. However, the foam liner at the top has started to deteriorate. I wore it for go-karting last week, and the sweat from my head made the liner start crumbling off. Not much, but still crumbled. Should I have any concerns about this helmet? I love this helmet, fits my head like a glove...still. If it's still good to use, I'd prefer to use it for a while longer.

There's only one way you'll really find out, thing is how much of a chance are you prepared to take on the outcome?

Are you guys serious? I land on my head at least every 6 months, which should really be new helmet time.

Thinking about it I'm about to get my 4th in 18 months so I'm about on track, one is my road/commuting lid though I'm more worried about the dings that gets on my desk.

Just killed mine, would love the bell super but am doing an event next weekend and the helmet isn't released til the first! Bugger

Jon Taylor - Member

I just make sure my helmet gets a regular inspection from an independent expert.

The only time I've seen you crash, you bust your hand, coincidence?

Every year or every other year. I tend to use it and then hand it down to my dad/brother/sister who ride little and never take knocks. I feel like I do my part in helping them look after themselves but in reality its just a way to justify a new colour/shape for the new bike/theme.