I just "scored" a DMR trailstar frame for £285
The recommended headset is
https://www.dmrbikes.com/Catalogue/Frames/Spares/Headset
Top Bearing: 45/45, 41.8 OD, 30 ID.
Lower Bearing: 36/45, 51.8 OD, 40 ID.
So given I have a 1.5 FSA (36/45) crown race ... both bearings a couple of 1 1/8 hope shims... a FSA top seal bit and the split job for inside the top bearing am I missing anything?
https://photos.app.goo.gl/bSaYTtMbdVribs9R8
So given I have a 1.5 FSA (36/45) crown race … both bearings a couple of 1 1/8 hope shims… a FSA top seal bit and the split job for inside the top bearing am I missing anything?
Other than a SFN & top cap I don't think so.
(Oh and use https://www.labnol.org/embed/google/photos/ to embed Google photos)
Simon...
Thanks and thanks 😀
Loads of both SFN's and top caps.... and forks already have one fitted (unless i need to shorten it)