Hi, I'm looking to buy a headset press to fit a reducer and then 1 1/8 headset and normal forks to a F800. Will a Cyclus press do the job or do i need to buy a Park?
dunno offhand, but just measured mine (crap placcy verniers I'm afraid) and the step diameters are:
~26.4mm
~29.9mm
~33.7mm
~37.9mm
HTH
cheers Jond most helpful and the right size - would you recommend it?
Ah, good 🙂
Yeah, it's a pretty decent tool, with a simple ball-bearing race at one end to make the press action smooth - I've used it to fit an FSA, and a Hope.
(It wasn't the fault of the press, but the Hope was a bit of a PITA. I have the press blanks for both their headset and their xc hubs, but gawd knows what headset tool they're supposed to fit - I had to do one end at a time, very carefully, tho' once the cups were most of the way in the rest was fine.)