Garmin 1000 failing...
 

[Closed] Garmin 1000 failing to switch on.

 DT78
Posts: 10066
Free Member
Topic starter
 

Any things to try before I contact garmin support (out of warranty)

It loads the first page (says garmin) then shows the standby symbol and switches off. Does this both connected to the charger and not.

I have tried googling and a 'master reset' of holding lap and start together whilst switching on. This doesn't seem to do anything either...

?

EDIT - now it doesn't even load the first page. just dead.


 
Posted : 23/09/2016 8:54 am
Posts: 0
Free Member
 

Have you tried plugging it into a PC rather than just a charger? That'd be my next step, possibility that the PC trying to communicate might help.

Failing that, the Garmin out of warranty service is actually pretty good


 
Posted : 23/09/2016 9:14 am
Posts: 43883
Full Member
 

Try taking the SD card out too.


 
Posted : 23/09/2016 9:18 am
Posts: 0
Free Member
 

yup this a common problem. Take SD card out hard restart. I think it can hang up on the SD card map or its own sometimes


 
Posted : 23/09/2016 9:22 am
 DT78
Posts: 10066
Free Member
Topic starter
 

no SD card 🙁

I'll try plugging it in to the pc when I get home.

Any idea how much it might cost to send it back to Garmin?


 
Posted : 23/09/2016 12:59 pm
Posts: 6669
Free Member
 

Cost of postage there and then about £80 for me to get a refurbed 800 when mine died out of warranty. Refurbed model may as well have been new.

They did try help me before that but mine was water damage so not much hope.


 
Posted : 23/09/2016 2:42 pm
 DT78
Posts: 10066
Free Member
Topic starter
 

Plugging it into a PC let me do the reset. Lost all my data but seems to be ok again. Will find out tomorrow....


 
Posted : 23/09/2016 9:18 pm