Dt Swiss 240s Rear ...
 

[Closed] Dt Swiss 240s Rear Hub 142mm to Boost Conversion?

Posts: 76
Free Member
Topic starter
 

Is this possible?

I've seen a kit for forks for the 240 hub but can't see anything for spacing of the rear disc and axle?

Thanks!


 
Posted : 03/08/2017 10:15 am
Posts: 8892
Free Member
 

The DT Swiss 142 and Boost hubs use different hub shells and there's no conversion from 142 to Boost.


 
Posted : 03/08/2017 10:23 am
Posts: 76
Free Member
Topic starter
 

Doh - thanks!


 
Posted : 03/08/2017 10:24 am
Posts: 13850
Free Member
 

Not true, you can get a conversion kit for 240 hubs from Wolf Tooth

https://www.wolftoothcomponents.com/products/boostinator

I think you need the Boostinator DR


 
Posted : 03/08/2017 10:29 am
Posts: 8892
Free Member
 

Sorry, I should have said there's no conversion from DT Swiss and using a conversion will invalidate DT Swiss warranty.


 
Posted : 03/08/2017 10:37 am
Posts: 728
Free Member
 

You can also use the Roval boost adapter kit.


 
Posted : 03/08/2017 10:37 am
Posts: 3225
Free Member
 

No dice for a CL hub though.
6 bolt only


 
Posted : 03/08/2017 2:47 pm
Posts: 4378
Full Member
 

Surely to fit a 142mm hub in a 148mm frame you just need the correct placement of 6mm of spacers?


 
Posted : 03/08/2017 3:28 pm
Posts: 13850
Free Member
 

BearBack - Member
No dice for a CL hub though.
6 bolt only

Am sat here wondering if you could bodge the Centrelock to 6-bolt converter and the boostinator on the same hub. I don't think I'd want to ride it.


 
Posted : 03/08/2017 3:31 pm
Posts: 7120
Full Member
 

The rotor is moved outboard as well.

Do those spacers actually work, or do they fail horribly after a while?


 
Posted : 03/08/2017 3:31 pm
 Rik
Posts: 0
Full Member
 

Has anybody actually used the wolf tooth boostintator successfully with a dt240 hub?

I bought one, looked good quality but when pushed in to the hub it wasn't as tight a fit as the original dt one. When you tightened up the maxle there was still play in the wheel.

Wolftooth refused to replace as they said there adaptor was not at fault, as the o ring inside the adaptor was not structural so wouldn't make any difference to the fit. But with the wolftooth adaptor there was play in the wheel, with the original dt adaptor no play.


 
Posted : 03/08/2017 4:04 pm
Posts: 3225
Free Member
 

Am sat here wondering if you could bodge the Centrelock to 6-bolt converter and the boostinator on the same hub. I don't think I'd want to ride it.

I haven't seen a cl adapter that allows you to screw a rotor into it. If it exists, then yep, bodge away
edit.. i have actually.. problem solvers (or Paul) used to do one that cinched up against the splines.. its since been discontinued so I assume it was a horrible idea.


 
Posted : 03/08/2017 5:19 pm
Posts: 3225
Free Member