Hi everyone,
Seeking advice again!
Just setting up the groupset on my new Nomad and when I get into the higher cogs on the cassette the chain is jumping off the front chainring.
Its 148mm rear spacing and I have a boost crankset fitted, 73mm BB so one spacer on the driveside.
Chain seems fine when in the higher gears, not too tight or slack.
Any suggestions I could try?
Thanks
clutch mech?
Yes XT 11s clutch rear mech ( 1 x 11 set up)
Make sure the clutch is on, obvs but easily done. You might want to try a NW chainring, my XT 1x10 used to jump off until I swapped to a NW ring up front.
My xt 11 speed ring kept dropping chain
New n/w ring no issue
time for a new bike....
Managed to solve the problem guys, the quick link on the chain had not slotted in properly so when it was going over the chainring it was knocking it out of line!
Thanks for the replies 🙂