Topic starter
I would like a 3 speed hub for my mtb.
It should be as light as possible(under say 1000g), run a disc, have a gear spread something like 32:16 middle and the a high gear for fireroads and a low gear for when I need to spin up a hill.
It needs to be tough and servicable and the more bling you make it the more I'll pay.
Anyone making one?
Posted : 27/02/2010 10:14 pm
[url= http://www.sturmey-archer.com/products/hubs/cid/3/id/39 ]here's one I prepared earlier...[/url]
though it weighs a little more than sir requested... 1400gms
Posted : 27/02/2010 10:20 pm
and I can't figure out if it's 135mm for MTB?
Posted : 27/02/2010 10:22 pm
• Extra wide hub will accomodate a big rear end
LOL. Anyone here have a big rear end?
Posted : 27/02/2010 10:29 pm
LOL. Anyone here have a big rear end?
Don't we all? It's one of the 'benefits' of cycling, a well defined gluteus maximus 🙂
fair point though... so we just need to convince them to make it in a MTB sizing?
Posted : 27/02/2010 10:30 pm